Hi all,

I am trying to change the value of step per in the motor tuning, when i changed the value of step per to any value the Graph disappears and the velocity will become ZERO. and i am not able to enter the velocity the velocity will become ZERO even if  enter the new velocity value.

Any solutions?

Shivu.

I'm not sure on this one.  Some parameter is not right.  You might post this question to the General section and get more responses.

Steve

Just in case you ran into the same problem as I did... Go to Config > Ports & Pins > Motor Outputs. Make sure the axes you want to run are enabled with the check mark. Last week I was unable to use the Motor Tuning menu in mach and the graph was not working right either... It was because I had not enabled the axes in the Motor Outputs tab.

Josh G.