I'm not sure if this is the right place for this question, but has anyone used the Keling C35 BOB with the Gecko G201 or G203 drives? I see that they bill it as "quick connect" which is only really true is you use their drives. Does the little RJ45 -> pin-out board they supply match up to the Gecko drives? If not, I see a couple of options. (1) Make an RJ45 -> pin-out that does work or (2) Just strip back the drive end of an RJ45 cable. What have you done and how did it work out?
Any other comments about this BOB...Good or bad?
Thanks