Hello Guest it is June 16, 2019, 11:22:46 AM

Author Topic: Homing  (Read 5441 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,843 25,843
  • Carnoustie, Scotland
    • View Profile
Re: Homing
« Reply #10 on: October 07, 2010, 02:23:20 AM »
Hi,

I'm having the similar problem.
When homing it goes to switch but don't reverses. How can I configure so that it comes off the switch?

Thanks


Do you have the Ajax controller as well or are you using the parallel Port?
Hood
Re: Homing
« Reply #11 on: October 07, 2010, 02:48:51 AM »
Do you have the Ajax controller as well or are you using the parallel Port?
Hood
opps, I forgot to mention. I use parallel port (DIY router build).
My CNC Store: http://liana-tech.com
_____________________________

Offline Hood

*
  •  25,843 25,843
  • Carnoustie, Scotland
    • View Profile
Re: Homing
« Reply #12 on: October 07, 2010, 03:01:55 AM »
Mach only backs off enough for the switch to deactivate, if yours is not doing that then either it is a bouncy switch or you have noise issues. Increasing the debounce interval On General Config page will help to determine if that is the problem but it is masking the issue rather than curing it.

Hood
Re: Homing
« Reply #13 on: October 07, 2010, 04:59:54 PM »
Hi,

I'm having the similar problem.
When homing it goes to switch but don't reverses. How can I configure so that it comes off the switch?

Thanks



Swap the X+ and X- switch wiring. It may be activating the wrong switch, and then it can't reverse.
« Last Edit: October 07, 2010, 05:03:19 PM by Captain Midnight »
Re: Homing
« Reply #14 on: November 08, 2010, 10:51:40 PM »
I have the same issue.On start up the first homing cycle will work.If I
try to home again I can only hit the switch but not back away.i then get a
"cannot use G53 incremental" message.This machine has a ss and 3.42.40.