Hello Guest it is September 15, 2019, 01:45:34 PM

Author Topic: Mach 3 Licence  (Read 6176 times)

0 Members and 1 Guest are viewing this topic.

Offline ger21

*
  • *
  •  6,288 6,288
    • View Profile
    • The CNC Woodworker
Re: Mach 3 Licence
« Reply #10 on: October 30, 2010, 07:28:14 PM »
The card itself works fine under windows 7 but what u cannot do in windows 7 is change the card to EPP and as far as i understand Mach3 needs it to be in this mode.

I know Gecko recommends EPP mode for their G540, but I think SPP mode also works.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline Hood

*
  •  25,849 25,849
  • Carnoustie, Scotland
    • View Profile
Re: Mach 3 Licence
« Reply #11 on: October 30, 2010, 07:32:46 PM »
Will a BIOS setting affect a PCI card?
Hood

Offline RonC

*
  •  32 32
    • View Profile
Re: Mach 3 Licence
« Reply #12 on: October 31, 2010, 06:05:44 AM »
Hood
you could be right, it probably only affects the on board port, sorry I hadn't thought of that!
RonC