I'll try and do a little photo/video shoot in the next few days. Yag isn't on the tooling plate yet, but basically its controlled as a spindle, so you can use the spindle override to increase or decrease the pulse rate on the fly. Same goes for the dispenser and the spindle itself.
The machine itself is designed for 3d circuit board manufacturing. 5 axes so we can do contoured pcb milling and laser engraving and direct circuit writing using conductive inks via the dispenser. The offset buttons on the screen allow you to mill a track, then move the dispenser to the zero point, start up mach in dispenser mode, and dispense into the track you just milled.
Theres a whole lot of r&d still going into this but I will share some photos and videos when the time is right!