Hello Guest it is August 20, 2019, 08:49:22 AM

Author Topic: problem mach3 nide help  (Read 1591 times)

0 Members and 1 Guest are viewing this topic.

problem mach3 nide help
« on: October 28, 2010, 07:27:06 AM »
hi sorry for my english write it as best I can , the problem that i have .My mill is working worng what happend when it start working with it some times it works good for about a hour some times for 2 hours
and then it starts breaking parts , some times the scream on my monitors freezes and the mill lost its direction, But if i restert the PC it works ok but i need to restert PC every time when im changing the g code . i have  2 cnc and 2 gecko driver  g540 PC 1 it is from dell 3.4ghz memory ram 1g secend PC is from ibm 3.0ghz and 1g of ram I found the forum replies that it may be AntiVirus , but I threw AntiVirus i chicking the steppers moters it is working ok motor doesnt lose its stepp
 can u help me what can be the problem   help me please

Offline Tweakie.CNC

*
  • *
  •  7,884 7,884
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: problem mach3 nide help
« Reply #1 on: October 28, 2010, 07:45:53 AM »
Hi komar1970,

Welcome to the forum.

You could try following the optimization steps towards the bottom of the page here http://www.machsupport.com/downloads.php

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.