In installed my licensed copy of mach2 software on my shop computer that is connected to my mill and that is
working OK. Then I decided I would like to also install it on my office
computer so I could use it offline to sanity check .NC programs generated by my
CAM software. When I installed it I opted to NOT install the driver
because the office computer already uses the parallel port and I didn't
want to generate any conflicts. It installed OK, but if I do an "about mach2"
form the help menu it says it is running in the demo mode. I didn't
think much about this until this evening when I found out that as
installed it is limiting the length of programs I want to test to just
under 1000 lines. Does anyone know how to get around this without
installing the driver? (which I am assuming is the problem). The license file is present in the program folder.