Dave,
I have tried MSM again,and have it loaded on a new PC for the machine only. I ran the latest setup on the House PC and get th esame thing also. Load a file, and proceed to run, press cycle start, and goes to thee first line, and just quits, searches, and then runs a few lines, without doing anything ,and stops again. OK while it is in stoped mode,I am lookng for what might be happening on the screen, to see whats going on, first at the top, it says pulley too fast for.. clicking on path, to enlasrge the screen, it takes off again, and then stops.. Tried this on the Machine PC, and the same thing happens, only it is supposed to cut a small hole, but is in some kind of arc mode, and the tool path is way bigger than the whole part is. Says there is an error, I J command, but on the other PC it just stop's. Uninstalled both MSM and Mach 3.43.22 and went back to 3.42.32 and everything is fine..Except when the screen loads, Mach flash is first, then a White screen, for about 9 seconds, then the screen set loads. I'm going back to the screen s that I have, and will just wait, for somemore fixes. Just not willing to make a postive disicion as of yet. I think i had posted this before, when MSM first came out. Maybe It's Just My Stuff Too! Thanks, Hank S.