Hello Guest it is June 21, 2024, 03:56:17 PM

Author Topic: Slow setup speed with my video probe…  (Read 5816 times)

0 Members and 1 Guest are viewing this topic.

Offline Glad

  •  19 19
Slow setup speed with my video probe…
« on: December 23, 2010, 02:16:32 PM »
Hello everybody,
here is my setup for video probing. I’m dissatisfied with setup speed of my video probe… It takes a lot of time to adjust and locate starting point of a fixture/part. Do you know another, faster, more precise way of finding edges, hole center on a part/fixture/table?

Offline RICH

  • *
  •  7,427 7,427
Re: Slow setup speed with my video probe…
« Reply #1 on: December 27, 2010, 04:16:39 PM »
The only video probing, etc i have done is with COPYCAT. To use it you will need an NFS license and it will do more than just finding a center and edges. A write up on COPYCAT can be found in Members Docs.
It has appendixes which describe modifications  to a video camera. I also use an XBOX 360 along with it.
The above is just one way.

You say not satisfied with setup speed .......are you meaning how long it all takes?
I just put ground piece in the chuck and visualy find stuff many times as it's easier and quicker and just as accurate.