Hello Guest it is December 01, 2024, 03:25:32 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: I've downloaded the software and can figure out where to put my liscense info.  (Read 5155 times)

0 Members and 1 Guest are viewing this topic.

Offline bryscnc

*
  • 1 1
I've downloaded the software and can figure out where to put my liscense info.
« on: August 21, 2006, 06:40:12 PM »
well I have purchased the software and I having problems getting the full version registered, Can anyone help. I have email the company.
Logged

Hood

*
Re: I've downloaded the software and can figure out where to put my liscense info.
« Reply #1 on: August 21, 2006, 07:07:49 PM »
Just put the license file you got by email into your Mach3 folder, that should be all you need to do. The next time you start Mach you can go to the help menu and look at "about" and you should see your name.

Hood
Logged

ynneb

*
Re: I've downloaded the software and can figure out where to put my liscense info.
« Reply #2 on: August 21, 2006, 08:08:46 PM »
Logged

Offline Wade Barrineau

*
  • 5 5
Jog Step doesn't work
« Reply #3 on: September 15, 2010, 05:20:04 PM »
 ???
I just had to reload mach3 due to a computer crash. Everything is fine except for jog step
The unit jogs just fine on continuous.
When I bring up the flyout and select step, nothing happens.
I have to use the reset to get the system to operate again, and then only on continuous.
Never had this problem before.
Any ideas????
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: I've downloaded the software and can figure out where to put my liscense info.
« Reply #4 on: September 15, 2010, 05:55:07 PM »
If you attach your xml I will have a look and see if I can figure out the problem.

Hood
Logged

Offline Wade Barrineau

*
  • 5 5
Re: I've downloaded the software and can figure out where to put my liscense info.
« Reply #5 on: September 16, 2010, 02:13:15 PM »
Hood,

Thanks for the reply.
I was finally able to talk to the guy who built the control box. He asked if the new computer was an HP, which it is.
He said that he has had issues with HP running Mach3. I going to try another make.
Have you heard of a similar problem?

Wade
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: I've downloaded the software and can figure out where to put my liscense info.
« Reply #6 on: September 16, 2010, 02:35:50 PM »
Some computers can have problems, usually its not brand specific and I dont think I have ever heard of HP computers causing issues but it could be possible that some do.
If you have another computer you could try it but first check that the step increment is not a tiny value as it may actually be moving but just so small you dont see it.

Hood
Logged
Pages: 1   Go Up
« previous next »