Hello Guest it is March 29, 2024, 06:27:09 AM

Author Topic: spindle motor  (Read 7193 times)

0 Members and 1 Guest are viewing this topic.

spindle motor
« on: October 08, 2010, 02:35:04 AM »
Hi , have a router with a normal on off type brushed router and its way too noisy.What are the alternatives? a stepper or servo? or a brushless dc ? does anyone make one with the collet chuck already attached? Have drawn a blank surfing the web so would be grateful for any help from you guys
thanks

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
PEACE
Re: spindle motor
« Reply #2 on: October 08, 2010, 05:02:57 AM »
Nice but a little out of my price range. >:(
Re: spindle motor
« Reply #3 on: October 08, 2010, 10:53:50 AM »
Hey, I have one of those! I have just tried it out on my workbench but it runs very quiet.
Re: spindle motor
« Reply #5 on: October 10, 2010, 03:22:31 PM »

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: spindle motor
« Reply #6 on: October 10, 2010, 03:45:57 PM »
A new router speed control is coming out in a few weeks that should let you run your router at much slower (and quieter) speeds while still giving good power. There's more info in a thread at CNC Zone, but it's forum has been down all day.

http://www.vhipe.com/product-private/SuperPID.htm
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline budman68

*
  • *
  •  2,352 2,352
    • View Profile
Re: spindle motor
« Reply #7 on: October 10, 2010, 04:19:25 PM »
Ger, could you pass on the link on the zone, please?

EDIT: Found it:  http://www.cnczone.com/forums/diy-cnc_router_table_machines/112658-super-pid_new_low-cost_router_speed_controller.html

Thanks,
Dave
« Last Edit: October 10, 2010, 04:33:21 PM by budman68 »
----------------------------------------------------------------------
Just because I'm a Global Moderator, don't assume that I know anything !

Dave->    ;)

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: spindle motor
« Reply #8 on: October 10, 2010, 04:32:52 PM »
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: spindle motor
« Reply #9 on: October 11, 2010, 12:49:15 AM »
Hi, the new low cost controller seems to be the way to go but have just sent off for a proxxon router as it has good write ups regarding noise levels. May keep my original router and try it if I can get hold of this new controller.