Hello Guest it is December 06, 2021, 12:35:31 PM

Author Topic: How do I setup so mach3 starts with certain codes.  (Read 1622 times)

0 Members and 1 Guest are viewing this topic.

How do I setup so mach3 starts with certain codes.
« on: October 30, 2014, 10:04:28 PM »
How to I set up mach3 so at start up it automaticly goes to say "G20 G55 M6T1" and make sure turn tool offset off etc?

Offline RICH

*
  • *
  •  7,419 7,419
    • View Profile
Re: How do I setup so mach3 starts with certain codes.
« Reply #1 on: November 01, 2014, 08:08:59 AM »
You can use an Initialization Macro.

An example for my lathe can be found in Threading on the Lathe - Mach3Turn writeup, Apendix "C" page 57.


RICH