RICH,
I'm gunna try this one more time,Last two posts are trashed. The fourm has always been a pain in my a$$ to post on,for reasons beyond my control. If this one post does not post,I GIVE UP! PERIOD.... Now to business, I have the ability to change the Line Type in my CAD program,and in doing so, have LC recognise the change in line type,and does it's own tabbing solution. I have enclosed 4 picts. of my CAD,changing the line type,and this has been more efficiant in producing GCode for the tabbing. It does save alot of time and can be altered to acomidate where the tabs are placed,and can be edited out of the corners if so wished. That had been the problem as I encountered before. Now with the changing of the line type,it has proven to me that this is quite faster, and it also follows curves and slots inward and outward. So this could be done as manual, or edited, for keeping the dash's out of the material where not needed. Simple, Yes ,but I have yet to try it on the machine to get a real sense of what it LOOKS like, and how correct it is.I have loaded the GCode in Mach,and have done in SIM Mode,and it seems perfect to run. Only time will tell,and wonder if there are any hitches, yet to be seen. So the enclosed 4 picts are to get a feel for what is going on. Enjoy !! Thanks, Hank S.