Hello Guest it is January 26, 2020, 03:04:05 PM

Author Topic: I do not understand  (Read 2245 times)

0 Members and 1 Guest are viewing this topic.

I do not understand
« on: August 22, 2010, 07:16:53 AM »
Good day to you all,

The question is very simple, but for me not understandable.  ???
in the main screen of Mach3, there is a part that shows me where the actual milling point is. (middle top screen)
This correspond to the GCode on the top left side of the screen.
These steps, what is their measurement ? mm, inch, or other.

I thought it where MM,

Thomass,

Offline Tweakie.CNC

*
  • *
  •  8,107 8,107
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: I do not understand
« Reply #1 on: August 22, 2010, 11:17:09 AM »
Hi Thomss,

The X,Y,Z,4 DRO's are in Units.
If you have selected native units as mm then the DRO's are in mm. (If you have selected native units as Inch then the DRO's are in Inches)
The units for the 4 DRO is usually always Degrees.

Hope this helps,

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: I do not understand
« Reply #2 on: August 22, 2010, 12:23:39 PM »
Thank you Tweakie, That is exactly what i mend, this makes me better understand.

Offline Tweakie.CNC

*
  • *
  •  8,107 8,107
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: I do not understand
« Reply #3 on: August 22, 2010, 02:25:01 PM »
Mijn Genoegen.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.