Hello Guest it is April 18, 2024, 07:34:11 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach 3 help  (Read 2327 times)

0 Members and 1 Guest are viewing this topic.

Offline neiter13

*
  • 6 6
    • View Profile
Mach 3 help
« on: July 24, 2010, 02:44:29 PM »
I'm trying to make a part and i have all the measurements correct from the original but when i have mach 3 try and cut it, it is 1/32nd off all around. is there a offset within mach 3 that i don't know about. any ideas would be helpful.

- neiter13
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Mach 3 help
« Reply #1 on: July 24, 2010, 03:05:28 PM »
Not unless your'e using G41/G42 in your code.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Pages: 1   Go Up
« previous next »