Hello Guest it is March 28, 2024, 04:19:34 AM

Author Topic: Driver test AGAIN!  (Read 4225 times)

0 Members and 1 Guest are viewing this topic.

Offline mrpeja

*
  •  114 114
    • View Profile
    • Embroidery Machines
Driver test AGAIN!
« on: July 16, 2010, 01:21:54 PM »
Hi,
I have read all about driver test and problems with PC hardware on forum.
I'm wondering: How big Max Variation should be and not to disturb Mach3 work?
I have new mainboard and get Max variation of 30 uS. Is this good  enough or bad for plasma table?
Regards

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: Driver test AGAIN!
« Reply #1 on: July 16, 2010, 05:32:54 PM »
I think the closer the pulse per second at the top to the selected Kernel speed and what the graph line looks like is most important.
RICH

Offline mrpeja

*
  •  114 114
    • View Profile
    • Embroidery Machines
Re: Driver test AGAIN!
« Reply #2 on: July 17, 2010, 03:56:37 AM »
Hi Rich,
Graph line looks ideally flat, but from time to time has spikes. The biggest spike is when 30 uS variation is reported.
I don't know if this will disturb pulse stream, producing jerk.
mrpeja

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: Driver test AGAIN!
« Reply #3 on: July 17, 2010, 07:16:40 AM »
try it out and see what how it works.

RICH

Offline mrpeja

*
  •  114 114
    • View Profile
    • Embroidery Machines
Re: Driver test AGAIN!
« Reply #4 on: July 18, 2010, 02:38:48 PM »
Hi RICH,
I tested my mainboard in real condition and with scope on step input. Jitter is noticeable and motor produces ugly sound.
I ran drivertest again. Here are results:
At kernel speed of 25KHz it has 24350 pulses per second (I think no good)
Max variation is 30 uS
Any HELP?
What is Special parallel port diriver for?
Mrpeja

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Driver test AGAIN!
« Reply #5 on: July 18, 2010, 02:41:15 PM »
Turn off C1E or EIST in the bios
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline mrpeja

*
  •  114 114
    • View Profile
    • Embroidery Machines
Re: Driver test AGAIN!
« Reply #6 on: July 21, 2010, 01:02:05 AM »
Yes, I alreadu turned off it, but nothing better