Hello Guest it is June 16, 2019, 05:47:17 PM

Author Topic: Manual Motor tuning  (Read 20838 times)

0 Members and 1 Guest are viewing this topic.

Re: Manual Motor tuning
« Reply #60 on: November 07, 2006, 08:27:43 AM »
Shizzam !!!!!   ;D

Hooked up to the 24Volt PSU that stepper is Flawless !!!
Had a feeling it was a lack of tourqe thang'.
Thanks for all the help guys .

Offline Chaoticone

*
  • *
  •  5,502 5,502
  • Precision Chaos
    • View Profile
Re: Manual Motor tuning
« Reply #61 on: November 07, 2006, 09:53:39 AM »
Good Job Yoda :D
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: Manual Motor tuning
« Reply #62 on: November 07, 2006, 10:04:33 AM »
Thanks ..  Glad the frustration is over   ;D

Heres a little tip for noobies Like me.
lol
To start the story I load the roadrunner and scale it down to fit on the chunk of aluminum I have in the vise.

After I realized all was well with the motor I decided to go to the Auto Step Cal thing to check distance ..  lol
Keep in mind I have the scale down setting still on the main page ..
LOL

I got to move the Z 2" and it moves 1/4" ?????  I say WTH ???
I tell it that it moved a quarter inch and it set the step's per at about a Bizzilion LMAO

Then when I jogged the motor just laughed at me ..

Then it dawned me that scaling down the axis is a Global Thang' !!!   nuk

Lesson learned.
when auto Calibrating the steps per be DAMN sure scaling is at 1.00      ;D
Re: Manual Motor tuning
« Reply #63 on: August 20, 2007, 03:22:19 PM »
Anybody find out what that step/dir pulse (0-5) Thing is all about i have the same HF mill 33686 as you and am having problems with accuracy