Hello Guest it is November 21, 2019, 02:28:34 PM

Author Topic: Mach 3 & C10 breakout spindle control?  (Read 3194 times)

0 Members and 1 Guest are viewing this topic.

Mach 3 & C10 breakout spindle control?
« on: June 22, 2010, 03:53:48 AM »
Hello I'm new to this and need some training wheel help please!

I'm using M3 with a C10 breakout and id like to know how i could control the speed of my spindle, the only info i have on the spindle speed controller is  on the link below which has a diagram (and its in Japanese). Will the C10 do a variable Voltage/Current?  into the VS,VC or CC inputs?. Also how come i cant ramp my spindle speed up past 8000rpm (not that it matters at the moment)

I can turn the spindle on and off but i have no speed controll, if any one could help that would be great and much appreciated.

http://www.lingnangroup.com/ProductInfo.aspx?ProductID=229&LevelCode=00101001


Thanks

D


« Last Edit: June 22, 2010, 03:59:54 AM by Darian »

Offline Tweakie.CNC

*
  • *
  •  8,008 8,008
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach 3 & C10 breakout spindle control?
« Reply #1 on: June 22, 2010, 04:05:48 AM »
Hi D,

Unfortunately the C10 does not have the on board variable speed control (it's the model C11 that has this). However this does not stop you varying the spindle speed using a seperate PWM / 0 - 10 Volt board for controllingl your VFD.

Tweakie.

Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: Mach 3 & C10 breakout spindle control?
« Reply #2 on: June 22, 2010, 04:28:38 AM »
Hi Thanks

Will look into it

Cheers

D