Hello Guest it is June 25, 2019, 02:42:43 AM

Author Topic: change Z position  (Read 1796 times)

0 Members and 1 Guest are viewing this topic.

change Z position
« on: May 18, 2010, 01:21:12 PM »
i load "Z change.tap" to mach3 and it run( i use sheetcam) , then in line 30 , i press "Feed hold" then "Reverse run". Is apparently no problem but issue is Z .
 i see when go reverse, approximately When reach to line 29 . is Z dro changed .
is very bad.this is big problem.
Z dro goto 52 and plasma dont work and dont cut.
Please guide me .
**Even a clock that does not work is right twice a day**

Offline Hood

*
  •  25,847 25,847
  • Carnoustie, Scotland
    • View Profile
Re: change Z position
« Reply #1 on: May 19, 2010, 10:41:01 AM »
As has been said before, if you are using the demo version then, according to what Art told me, the Reverse Run does not work correctly. Because you are attempting to use Reverse Run that is likely your problem.
Hood
Re: change Z position
« Reply #2 on: May 19, 2010, 10:54:01 AM »
no, reverse run work well
**Even a clock that does not work is right twice a day**