Hello Guest it is March 28, 2024, 08:47:50 AM

Author Topic: Spindle drive problems.  (Read 17213 times)

0 Members and 1 Guest are viewing this topic.

Re: Spindle drive problems.
« Reply #40 on: May 04, 2010, 03:47:00 AM »
Hi Sweep, I thought I had sorted out the creep but it started again. Decided to take the LYNX08 unit out of the base unit and mount it in a separate box with its own supply to see if that cures it. I'm a bit concerned as once when it crept one if the red warning lights came on on the Z axis drive. Denford did some strange things to make the spindle lock in the correct position for the tool changer so I;m being carefull, Will keep you posted. putting in M5 S0 didn't solve the problem or the debounce alteration. Jim
Re: Spindle drive problems.
« Reply #41 on: May 15, 2010, 01:11:52 PM »
Ok think I have sorted it, My LYNX08 spindle board had a capacitor blown on it, I was told it made no difference to the drive unit, that was true, however I had the caspacitor replaced and all seems OK.  AT THE MOMENT!!!!