Hello Guest it is November 22, 2019, 06:11:05 PM

Author Topic: Newbie servo question  (Read 5572 times)

0 Members and 1 Guest are viewing this topic.

Re: Newbie servo question
« Reply #10 on: October 10, 2006, 06:24:32 PM »
Good to know.
I scaled it down to .75 and slowed the feed rate down and she cut like a dream.
(Cutting Aluminum)
I need to set up the Z axis and Im golden.
anybody know of a good source for toothed pullys ?
the surplus place I invade daily is out of any of the size I need.
I will probably go to Grainger if I dont find a good online source.
Thanks again peeps.
Re: Newbie servo question
« Reply #11 on: October 10, 2006, 06:29:02 PM »

Offline Chaoticone

*
  • *
  •  5,630 5,630
  • Precision Chaos
    • View Profile
Re: Newbie servo question
« Reply #12 on: October 10, 2006, 06:31:43 PM »
Stock Drive, Google them. Good people to deal with, if they don't have it, you probably don't need it. They allso have a design wizard. You give it the pulley ratio, desired center to center. It will give you length, number of teeth, actual center to center. :)
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline Chaoticone

*
  • *
  •  5,630 5,630
  • Precision Chaos
    • View Profile
Re: Newbie servo question
« Reply #13 on: October 10, 2006, 06:33:24 PM »
OK, you win.
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: Newbie servo question
« Reply #14 on: October 10, 2006, 07:00:39 PM »
Thanks guys ..
All I care about right now is the Bore size.