Thnaks, Hood.
I'm a Gcode newbie - what gcode would be specified to cause an offset. Something is off because when I load the file into Mach, the new x and y are beyond the size of any of the parts. (like 38 inches for X when the extend of the part is only 8 inch o n X.)
If I have the gcode to cut out a rectangle, and then want to cut out a total of 5 just like it, how do I write the gcode to do that? (if there is a good refernce somewhere to put me to, I would go look at that.) Just looking at the codes, I don't see one to specify a new offset.