Hello Guest it is April 19, 2024, 04:07:10 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Machine disoriented after line 9000  (Read 2455 times)

0 Members and 1 Guest are viewing this topic.

Offline Blacktable

*
  • 1 1
    • View Profile
Machine disoriented after line 9000
« on: April 01, 2010, 12:41:28 PM »
I have a small CNC milling machine that I run with a laptop without any problem until Mach 3 start processing line 9.000 (approximatively). Does anybody know the reason for this, since I have been waisting a lot of time and material because of this problem.

Thanks
Logged

Offline N4NV

*
  • 398 398
    • View Profile
Re: Machine disoriented after line 9000
« Reply #1 on: April 03, 2010, 12:23:24 AM »
Is it the 9000th line or line number 9000?  An unlicensed version of Mach is only good for 500 lines.  If your program is numbered every 20, i.e 20, 40 60 80 etc, then an unlicensed version of Mach would stop around line 9000. 

Vince
Logged
Pages: 1   Go Up
« previous next »