Hello Guest it is March 28, 2024, 08:45:16 AM

Author Topic: Save Settings  (Read 2631 times)

0 Members and 1 Guest are viewing this topic.

Offline CNCdn

*
  •  11 11
    • View Profile
Save Settings
« on: March 12, 2010, 12:35:05 PM »
Obviously, I'm missing something ???
I can't seem to figure out how to save all my settings (motor pin allocations, limit switch conditions, motor tuning etc).
I choose "save settings" but when I try to "restore settings" and the program shuts down and I re-start it by opening "MyMill" file, I must re-set all parameters.
There's a trick here but I can't seem to find it. :-\
A little help please.
Alex

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Save Settings
« Reply #1 on: March 12, 2010, 01:36:27 PM »
Change your settings then shut Mach down and restart and they should be saved. If they are not then it would seem your xml is set as read only.
Hood

Offline CNCdn

*
  •  11 11
    • View Profile
Re: Save Settings
« Reply #2 on: March 12, 2010, 03:22:58 PM »
Thanks Hood.
Don't know what I WAS doing but it obviously wasn't  that because I did EXACTLY that and everything WAS saved.  ::)
Thanks for your help.
Alex

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Save Settings
« Reply #3 on: March 12, 2010, 03:24:59 PM »
LOL no probs.

Hood