Third party software and hardware support forums. > PoKeys
high speed encoders
tantan:
hi,
i have a pokey with an encoder connected to pin 1 and 2, nothing else is connected to it. if i configure it as a normal encoder every thing works well, but if i enable the high speed encoder option in the pokeys configuration screen the raw encoder values don't increase or decrease while the numbers 1 and 2 in the configuration screen blink while i am turning the encoder. i use the latest pokey software, i upgraded the firmware of the pokey and i use the latest mach version.
hope you help.
tantan
the netherlands
borisz:
Hi!
Do not use fast encoders with Mach plugin yet.
New plugin which will support fast encoders is under work and shoiuld be released soon.
regards
Boris
tantan:
oke boris thank you for your reply,
i thought that high speed mpg's where working allready, i'll wait for the update.
thanks
tantan
poppabear:
Fast Encoders IS supported in the latest Mach 3 plugin
I guess Boris and them are doing something in the firmware.
scott
borisz:
Will check firmware.
regards
Boris
Navigation
[0] Message Index
[#] Next page
Go to full version