Hello Guest it is September 22, 2023, 03:19:23 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: problem slaving X and A in Mach3  (Read 3109 times)

0 Members and 1 Guest are viewing this topic.

Offline dnnsigns

*
  • 4 4
    • View Profile
problem slaving X and A in Mach3
« on: February 25, 2010, 09:23:44 AM »
Hi can any one help please I am trying to slave A to X to drive the gantry, before slaving both steppers move independently, when I slave, A stops working help please.
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: problem slaving X and A in Mach3
« Reply #1 on: February 25, 2010, 09:59:44 AM »
How have you set them up?
Are they the same steps per unit?
Hood
Logged

Offline dnnsigns

*
  • 4 4
    • View Profile
Re: problem slaving X and A in Mach3
« Reply #2 on: February 25, 2010, 10:47:42 AM »
Hi I have sorted it all working fine. For some reason one of the steppers was running in reverse giving the appearance of only 1 stepper running, changed direction and bingo.

Hope this may help someone.

Neil
Logged

Offline dnnsigns

*
  • 4 4
    • View Profile
Re: problem slaving X and A in Mach3
« Reply #3 on: February 25, 2010, 10:49:29 AM »
Thanks for your reply Hood I must have been typing my post at the same time as you.

Neil
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: problem slaving X and A in Mach3
« Reply #4 on: February 25, 2010, 11:47:49 AM »
Glad you got it :)

Hood
Logged
Pages: 1   Go Up
« previous next »