Hello Guest it is December 04, 2021, 05:52:14 PM

Author Topic: Fusion 360 and Mach 3 post error  (Read 2941 times)

0 Members and 1 Guest are viewing this topic.

Fusion 360 and Mach 3 post error
« on: August 01, 2014, 11:41:01 PM »
I just generated my first code in Fusion 360. When I attempt to run the code I get this
error : Current point same as end point of arcLine 21. I was changing setting in the general
config section. I changed the Distance Mode and IJ mode hoping that a change would help
my error. Now I have no idea what those setting should be.
Need some help this is a bit over my head.

Offline Tweakie.CNC

  • *
  •  8,865 8,865
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Fusion 360 and Mach 3 post error
« Reply #1 on: August 02, 2014, 03:14:52 AM »
Hi Golash,

Normally, Distance Mode would be set to Absolute and IJ Mode set to Incremental.
Did changing the IJ Mode to Absolute solve the problem with running your code ??