Hello Guest it is January 29, 2020, 10:44:05 AM

Author Topic: 2nd parallel port card issues  (Read 8298 times)

0 Members and 1 Guest are viewing this topic.

Offline BarryB

*
  •  267 267
    • View Profile
Re: 2nd parallel port card issues
« Reply #20 on: February 02, 2010, 07:43:28 PM »
I should mention that my machine was working fine, ports and pin wise and all functions, X, Y, Z, B, C, home switches, limit switches, and spindle control with the smooth stepper.  The smooth stepper was losing connection though, sometimes a few hours into a job.  I think the ports, pins, and all are fine.  It's the new port being seen at all.  Sorry to mention, but a lot of the suggestions are for basic setup, not for a transfer from a smooth stepper to a parallel port card and getting the card to work with Mach.

Barry