Third party software and hardware support forums. > Newfangled Solutions Mach3 Wizards

Race Car parts

(1/1)

Vmax:
Pictures of racecar parts built with Mach3/NF. This piece adapts Hendricks swaybar into a Roush mount onto a Yates Chassis. It was built with NF conversational programming.
Inside circle
Outside circle
Outside square
Inside square
Key slots
Drill pattern

No CAD No CAM No Gcode programing
Just went from modual to modual and poof it was done.
Good job Brian keep up the good work.

(:~)= Terry

ynneb:
Thats a great advertisement for NewFangled.
You did this using a $50 dollar plugun for Mach3 ?
Sound like a fantastic deal.

Brian Barker:
Very nice to see you using them as I hoped many would! It is cam for the people that make parts :)

I am going to have to get working on my 64 Chevy truck, you guys are having all the fun. ;)

Vmax:
Another set of adaptors this time Roush Bar to Yates Chassis. Guys this is too easy I better unload that NF stuff before I get Lazy!!!!!!!   NOT.....

Now if I only had that tapping Wizzard to go with it !!!!!!!!!!!!!!!!!!!!!!!

Doing  a Front Motor plate is a lot of drilling and tapping...

Navigation

[0] Message Index