Hello Guest it is March 29, 2024, 03:25:01 AM

Author Topic: Hesatation? after arc move  (Read 2856 times)

0 Members and 1 Guest are viewing this topic.

Hesatation? after arc move
« on: September 13, 2006, 01:55:01 AM »
Not sure how to word this but I'll try......I am using Mach 3 to run a servo driven burning machine and it just started stopping briefly or hesetating after an arc move.
   It doesn't stop the program, but pauses for a fraction of a second. At 150 ipm it is quite jerky. I don't remember changing anything........ But being new at this I can't say for sure!
     Thanks in advance, Steve
Re: Hesatation? after arc move
« Reply #1 on: September 13, 2006, 07:01:37 PM »
Try putting a G64 in the Gcode program

How is it then?
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Hesatation? after arc move
« Reply #2 on: September 13, 2006, 08:21:16 PM »
 Thank You for the reply, I discoverd that I han "No Angular Discrimination" unchecked.
 We are happy now!  Thanks Steve