Hello Guest it is September 20, 2019, 05:14:30 PM

Author Topic: Mach3 + Ajax cnc retrofit kit  (Read 6579 times)

0 Members and 1 Guest are viewing this topic.

Mach3 + Ajax cnc retrofit kit
« on: November 14, 2009, 07:02:09 PM »
Is there anyone that is using the mach3 and Ajax cnc kit with the d3Io board that can give me
any good or bad thoughts

I'm Looking to retrofit my fryer MB15 mill with a milltronics control i have a burned axis drive that cost over a grand to
repair an no programmable spindle  that's about the same cost of the kit


thanks for your help and thoughts
Adam
Re: Mach3 + Ajax cnc retrofit kit
« Reply #1 on: November 14, 2009, 07:29:53 PM »
Hi Adam,
  Ed has an Ajax set-up.
http://www.machsupport.com/forum/index.php/topic,13112.0.html
Give him a shout.
Russ
Re: Mach3 + Ajax cnc retrofit kit
« Reply #2 on: November 14, 2009, 08:00:55 PM »

thanks Overloaded


Any One want to buy my old milltronics control
Adam
Re: Mach3 + Ajax cnc retrofit kit
« Reply #3 on: November 16, 2009, 05:11:53 PM »
Good lookin bed mill you have there. I would definitley go for the Ajax setup.

Ed
Ed VanEss