Hello Guest it is July 18, 2019, 07:49:00 AM

Author Topic: dwell for the spindle  (Read 4451 times)

0 Members and 1 Guest are viewing this topic.

Offline Chip

*
  • *
  •  2,057 2,057
  • Gainesville Florida USA
    • View Profile
Re: dwell for the spindle
« Reply #10 on: November 17, 2009, 08:51:10 PM »
Hi, Bryson

Well the a.01 didn't work hear ether prob. not a big enough move to show, Use g0 a0.1 and g0 a0

There is another way use some .m1s macro's, It's more involved, We'll look at it if needed.

Chip
« Last Edit: November 17, 2009, 11:38:04 PM by Chip »
Re: dwell for the spindle
« Reply #11 on: November 18, 2009, 12:42:30 PM »
how do i access the A axis.  I need it to put out the same signal that the spindle did earlier?