Author Topic: THREADING ON THE LATHE - MACH3 TURN  (Read 4805 times)

0 Members and 1 Guest are viewing this topic.

Offline RICH

  • Global Moderator
  • *
  • Posts: 7,302
    • View Profile
THREADING ON THE LATHE - MACH3 TURN
« on: November 03, 2009, 09:58:14 PM »
THREADING ON THE LATHE rev 3

This write up covers most aspects of threading on the lathe and is tailored to the Mach3Turn user.
The information is current for threading in Mach versions greter than 3.042.033.

Have Fun Threading,
RICH

NOTE: SEE REVISION LIST IN APPENDIX "D" FOR CHANGES
          REVISION 3 was deletion of a few lines of text on page 42.     RICH 2/3/12
« Last Edit: February 03, 2012, 04:56:38 PM by RICH »

Offline RICH

  • Global Moderator
  • *
  • Posts: 7,302
    • View Profile
Re: THREADING ON THE LATHE - MACH3 TURN
« Reply #1 on: December 22, 2009, 08:13:49 PM »
Another threading wizard was posted recently. It is called "Complex Threading(Lathe) . I incorporates some of the features which are described in the manual for the other two wizards and then some. Here is the link:

http://www.machsupport.com/forum/index.php?action=dlattach;topic=13434.0;attach=18904

I have started a new thread about it.
RICH