Hello
Guest
it is
December 03, 2024, 03:03:58 AM
Guest
Login
Register
Menu
Home
Help
Search
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Mill cutting too big
« previous
next »
Print
Pages:
«
1
2
Go Down
Author
Topic: Mill cutting too big (Read 10246 times)
0 Members and 1 Guest are viewing this topic.
Tef9
89
Re: Mill cutting too big
«
Reply #10 on:
November 01, 2009, 06:26:14 PM »
Hi Hood,
I have just looked at the wizzard, I can see no obvoius part to tell it where to start, attached is a screenshot. please note however this is on my 'inside in the warm' computer not the one with the issue.
Cheers,
Andy
Logged
Tef9
89
Re: Mill cutting too big
«
Reply #11 on:
November 01, 2009, 06:27:04 PM »
forgot to attach pic.
Andy
Logged
Hood
25,835
Carnoustie, Scotland
Re: Mill cutting too big
«
Reply #12 on:
November 01, 2009, 06:42:56 PM »
Ah Ok sorry I am used to the NewFangled ones see pic.
If you post the code when you can then it may point to the problem.
Hood
Logged
Tef9
89
Re: Mill cutting too big
«
Reply #13 on:
November 02, 2009, 04:03:08 PM »
Ok here is the code:
G21
F400
G00 Z3
G00 X5.7775 Y0
G00 Z1
G01 Z0 F50
G02 X5.7775 Y0 I-5.7775 J0 F400
G00 Z3
G00 X5.9 Y0
G01 Z0.8775 F400
G01 Z-0.1225 F50
G03 X5.9 Y0 I-5.9 J0 F400
G00 Z3
G00 X0 Y0
M30
Also attached is the picture of my settings from the mill ocntroller.
Andy
Logged
Hood
25,835
Carnoustie, Scotland
Re: Mill cutting too big
«
Reply #14 on:
November 02, 2009, 05:19:22 PM »
Change the IJ mode to Inc and see if that cures your problem, you will find it on the General Config page.
Hood
Logged
Tef9
89
Re: Mill cutting too big
«
Reply #15 on:
November 03, 2009, 01:19:39 PM »
Hood - you got it, changed to inc and everything seems to cut fine.
Thank you! and thanks to all for trying to help.
A
Logged
Hood
25,835
Carnoustie, Scotland
Re: Mill cutting too big
«
Reply #16 on:
November 03, 2009, 02:21:57 PM »
no probs
Logged
Print
Pages:
«
1
2
Go Up
« previous
next »