Hello Guest it is March 28, 2024, 12:11:04 PM

Author Topic: Retrofit kits for the Sieg X3 and Super X3  (Read 5742 times)

0 Members and 1 Guest are viewing this topic.

Retrofit kits for the Sieg X3 and Super X3
« on: August 27, 2006, 11:05:22 AM »
Hello all

Just a quick note to say that I have released a new retrofit kit for the X3 mills.

I offer several kits ranging from basic hardware through to hardware, motors, controller and of course a registered copy of Mach3. Kits are easy to install requiring no mods to the mill and do not detract from table movement ...in fact the Y is increased!

Our controller runs nicely with Mach3 so even if you already have your mill hardware arranged then have a look at our controller ... 4 axis 40V 3A per axis, microprocessor based with nice features and designed by us with safety in mind.

If this is of interest to you then please check out http://www.cnckits.com.au ..there are email links on the site so if you have any questions at all please feel free to send me a note.



Regards

Marc
PROMiCA - CNCKits
Melbourne Australia