I don't know what caused this but pin 1 of the parallel port stopped functioning as my X axis step output.  I tried using pin 1 as the direction output instead to no avail.  Tried using it with the Y and Z axis, but still no success.

Has anyone had this problem before?  I am using all of the output pins, so I can't just change to another pin.  I've tried upgrading to 3.45, without success, and given the port driver causing problems with laptops, I went back to version 2.65.

I know the parallel port output is the problem as I have tested the outputs with a digital probe.  It is not my breakout board.

Thanks in advance for any suggestions.

Ken Klausner

If you can try a normal type output such as coolant on Pin 1 and see if it works, if not then it would seem your parallel port is bad.

Hood