Hello Guest it is March 29, 2024, 03:15:30 AM

Author Topic: need asistance  (Read 2470 times)

0 Members and 1 Guest are viewing this topic.

Offline Toad

*
  •  58 58
    • View Profile
need asistance
« on: September 27, 2009, 10:07:22 PM »
Hi Everyone:

When my mill finishes a job, I have it programed to go to "0" the problem is , is that "Z" and "Y" go to zero, bit "X" does not. I have all three set up the same way in the config. settings. Why doesn't "Y" respond? ???

Toad

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: need asistance
« Reply #1 on: September 27, 2009, 10:17:55 PM »
Post your code here for us to look at.

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline Toad

*
  •  58 58
    • View Profile
Re: need asistance
« Reply #2 on: September 27, 2009, 10:33:37 PM »
I would if I could, but it is not connected to the internet, and has no cdr . Old computer, but works fine.  What I did was go into the config homing limits and set "X","Y" and "Z" to go to zero. Is this not correct, or do I need to do something else?

Toad