Hello Guest it is March 28, 2024, 07:25:50 AM

Author Topic: New 4th Axis Software website, www.CNCWrapper.com  (Read 7810 times)

0 Members and 1 Guest are viewing this topic.

New 4th Axis Software website, www.CNCWrapper.com
« on: October 04, 2009, 03:48:11 AM »
Pleased to announce new website

www.CNCWrapper.com

CNCWrapper V2 is a low cost, easy to use and very fast program which will convert a 2 1/2D or 3D Gcode program into Gcode suitable for 4th axis rotary machining.

Features include Rounding gcode generator, Syntax highlighting and more.

Visit www.CNCWrapper.com to download your demo software. The Demo version will convert and save your code so you can run the code on your machine.


Andrew

Offline budman68

*
  • *
  •  2,352 2,352
    • View Profile
Re: New 4th Axis Software website, www.CNCWrapper.com
« Reply #1 on: October 04, 2009, 01:52:27 PM »
Thanks for a great and very reasonable (read: CHEAP!) product with some great features, Andrew.

Purchased this morning and I look forward to using when time permits.

Dave
----------------------------------------------------------------------
Just because I'm a Global Moderator, don't assume that I know anything !

Dave->    ;)
Re: New 4th Axis Software website, www.CNCWrapper.com
« Reply #2 on: October 04, 2009, 04:49:59 PM »
Thanks for the comments Dave, I hope you get some good use from it.

Andrew
Re: New 4th Axis Software website, www.CNCWrapper.com
« Reply #3 on: October 07, 2009, 03:49:16 AM »
Just sent a paypal payment, looking forward to receive my license.

Jeff
Re: New 4th Axis Software website, www.CNCWrapper.com
« Reply #4 on: October 07, 2009, 08:57:02 PM »
Just sent my paypal payment too.   My rotary takes the place of my y-axis at present.  As soon as my Gecko arrives I will be making it into a true a-asx.  And will have a 4 axis machine.....   then the fun with mach3 will start all over again..... ;-)
Re: New 4th Axis Software website, www.CNCWrapper.com
« Reply #5 on: October 11, 2009, 04:00:37 PM »
Jeff / donrus

Thanks for purchasing CNCWrapper and good luck with your machine build donrus. Mach3 is fairly simple to setup for 4th axis, there is a small section in CNCWrapper help which may help with Mach3 setup.

Andrew