Hello Guest it is October 04, 2024, 11:17:41 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: rotary axis has stops moving  (Read 3326 times)

0 Members and 1 Guest are viewing this topic.

Offline smithvac

*
  • 3 3
rotary axis has stops moving
« on: October 19, 2012, 06:31:47 PM »
Hi
I am a new user and I have a rotary axis (a) that seems to have a limit.  I can go so far then it stops and only allows me to go the opposite direction.
What settings do I need to change to make it rotate indefinitely.
Any help would be appreciated.
Logged

Offline BR549

*
  • 6,965 6,965
Re: rotary axis has stops moving
« Reply #1 on: October 19, 2012, 07:31:03 PM »
Sounds like you may have a soft limit set for the A axis .

(;-) TP
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: rotary axis has stops moving
« Reply #2 on: October 20, 2012, 04:37:39 AM »
Yes as TP says you likely have the rotational; soft limits enabled, you will find that option on General Config page near the lower middle right section of that page.
Hood
Logged

Offline smithvac

*
  • 3 3
Re: rotary axis has stops moving
« Reply #3 on: October 20, 2012, 02:05:22 PM »
Thanks
I will have a look
Logged

Offline smithvac

*
  • 3 3
Re: rotary axis has stops moving
« Reply #4 on: October 22, 2012, 11:02:41 AM »
Hi I turned off the rotational soft limits and restarted the software.  It did't change.
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: rotary axis has stops moving
« Reply #5 on: October 22, 2012, 03:40:57 PM »
Can you attach your xml and I will have a look.
Hood
Logged
Pages: 1   Go Up
« previous next »