Hello Guest it is March 28, 2024, 08:55:07 PM

Author Topic: ss ran out data in middle of move  (Read 3796 times)

0 Members and 1 Guest are viewing this topic.

Offline eloid

*
  •  33 33
    • View Profile
ss ran out data in middle of move
« on: October 11, 2009, 12:33:41 AM »
I keep getting this error at the frist few lines of movement in my g code all the time !!!!!!!!!!!!!!!!! :o
pc is just run mach3 and keygrabber, but im not using the key grabber or my wire joystick when this happens.
controller freq is 1k....

It a slower pc is this amy problem?

Offline eloid

*
  •  33 33
    • View Profile
Re: ss ran out data in middle of move
« Reply #1 on: October 11, 2009, 12:47:40 AM »
I wonder if this a gode issue?..or pc was wondering if anyone wold like to "air test" my gcode, its 3-7 inch ish aplique maybe someone(  could air
test it for me( ~25 min of code)... and see if it repaetable on there smooth stepper, Cus my other problem has been the z axis dive down
Now the code has bee software simulaed and does diplace any issues.... how now i cant run it due to the above error
pausing all motion...

let me know.. if anyone could test it.. for me
Re: ss ran out data in middle of move
« Reply #2 on: October 12, 2009, 01:24:17 PM »
Check out this post i made http://www.machsupport.com/forum/index.php/topic,12565.0.html

To make sure it doesn't apply to you

Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable