Hello Guest it is September 19, 2021, 10:04:39 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach Turn  (Read 2786 times)

0 Members and 1 Guest are viewing this topic.

Offline andypasko

*
  • 3 3
  • Nuts are good.
    • View Profile
Mach Turn
« on: August 30, 2006, 03:17:08 PM »
How do I perform a finish pass on Mach turn ?   Any help would be appreciated.
Logged

Offline andypasko

*
  • 3 3
  • Nuts are good.
    • View Profile
Re: Mach Turn
« Reply #1 on: August 30, 2006, 07:18:25 PM »
Disregard... i got it to work.
Logged

Offline gary

*
  • 8 8
    • View Profile
Re: Mach Turn
« Reply #2 on: August 31, 2006, 12:10:13 PM »
Hi there how do you work out your roughing paths
Logged

Offline andypasko

*
  • 3 3
  • Nuts are good.
    • View Profile
Re: Mach Turn
« Reply #3 on: August 31, 2006, 04:22:50 PM »
I use BobCad V20 for the g-code.  Support page on their website has post for Mach3 Turn.
Logged
Pages: 1   Go Up
« previous next »