Hello
Guest
it is
April 24, 2024, 07:48:44 PM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
DRO Speed
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: DRO Speed (Read 3188 times)
0 Members and 1 Guest are viewing this topic.
Ray
70
DRO Speed
«
on:
October 03, 2009, 04:03:27 PM »
Just put Mach3 on another computer and when jogging, the DRO keeps going after I release the jog button for a second or two. Where do I fix this please?
Thanks
Logged
Hood
25,835
Carnoustie, Scotland
Re: DRO Speed
«
Reply #1 on:
October 03, 2009, 04:20:28 PM »
Sounds like your acceleration is set very low. When you release the key Mach decelerates to a stop so if that is slow then it will take a while after the button has been released.
Hood
Logged
ger21
6,295
Re: DRO Speed
«
Reply #2 on:
October 03, 2009, 05:06:35 PM »
Or, you have it set to incremental jog mode and it's jogging a specified distance with each push of the key.
Logged
Gerry
2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Ray
70
Re: DRO Speed
«
Reply #3 on:
October 03, 2009, 07:12:53 PM »
Thanks Hood and Ger21. It was the Acc. and Vel. settings. I should have taken a pen and paper to the shop and noted the settings on that computer, but instead I relied on my super memory (ha ha). Glad you both were here. Thanks again, Ray
Logged
Hood
25,835
Carnoustie, Scotland
Re: DRO Speed
«
Reply #4 on:
October 03, 2009, 07:20:25 PM »
Even easier would have been to copy the xml and paste it to the new computer, that would transfer all your settings
Hood
Logged
Print
Pages:
1
Go Up
« previous
next »