Hello Guest it is March 29, 2024, 01:08:22 AM

Author Topic: Should I remove the milltronics for mach3?  (Read 2658 times)

0 Members and 1 Guest are viewing this topic.

Offline dresda

*
  •  220 220
    • View Profile
Should I remove the milltronics for mach3?
« on: July 01, 2009, 09:42:08 PM »
Hi, Just bought a Milltronics 3 axis knee mill, 1997. the control has a 386sx control, glenteck drives & motors.
I was going to rip the control out and install the mach3 but it runs great and it conv, graphics.
Should I switch to Mach3 or wait until it quits.
How much work would be involved in putting on the Mach3?
Regards, Ray.