Hello Guest it is January 20, 2020, 01:36:35 PM

Author Topic: Engraved in Stainless  (Read 6541 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  8,093 8,093
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Engraved in Stainless
« Reply #10 on: June 09, 2009, 06:25:50 AM »
Nice job Ed.
What cutter or bit did you use ?

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: Engraved in Stainless
« Reply #11 on: June 09, 2009, 12:58:06 PM »
hand ground .250 sharp point carbide, depth of .010.
Ed VanEss

Offline Tweakie.CNC

*
  • *
  •  8,093 8,093
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Engraved in Stainless
« Reply #12 on: June 10, 2009, 08:23:17 AM »
Thanks Ed.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.