Hi,
I have read a few old posts with questions about problems with soft limits, but I didn't find an answer on my problem.
I'm using Mach3Version3.042.027 and SmoothStepper on my milling machine.
After I start Mach3 and send axis in home position, all soft limits work fine - also by maximal speed.
With manual moving isn't possible to exceed soft limit.
If now I start one of the program, soft limits are not working any more. Nor if the program was interrupted because of broken tool,
nor if program is finish normally.
Only if I press RESET button soft limits are working again.
This is in my case a very big problem, because my Z axes has only 115 mm and is very quickly on the limit.
Is there any possibility to solve this problem?