Hello Guest it is March 29, 2024, 08:42:15 AM

Author Topic: Muti-start threading....  (Read 27588 times)

0 Members and 1 Guest are viewing this topic.

Offline Tef9

*
  •  89 89
    • View Profile
Re: Muti-start threading....
« Reply #50 on: May 08, 2009, 10:26:00 AM »
Ok will give it a go tonight and report back, I think my z axis is moving too quick!

A

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Muti-start threading....
« Reply #51 on: May 08, 2009, 10:30:21 AM »
Ahhh, the Z was going at about 245mm/rev hmmm could this be the problem.  If so how do I get it to follow the speed set by the 'F'

A

That would be about  correct for the example you gave, ie your revs were 120rpm and pitch was 2.1mm so that would mean 120 x 2.1 = 252mm/min

In my example above I was probably getting the terminology wrong.

Can you do a single start thread no problem?

Hood

Edit
 just read again, were you meaning 245mm/rev like you said or per min?
« Last Edit: May 08, 2009, 10:35:25 AM by Hood »

Offline Tef9

*
  •  89 89
    • View Profile
Re: Muti-start threading....
« Reply #52 on: May 08, 2009, 10:35:30 AM »
Ok I will give the single start a go and post results.

A