Hello Guest it is April 24, 2024, 11:20:00 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Feed rate on start up.  (Read 4557 times)

0 Members and 1 Guest are viewing this topic.

Offline Jens H

*
  • 15 15
    • View Profile
Feed rate on start up.
« on: April 22, 2009, 08:06:27 AM »
When I start mach3 the Feed rate is 6 (6mm/min--very slooow)
When i JOG this feed rate is used. I can change it, but next time i start Mach3 it is 6 again. Where can I change this value so it's default?
Logged

Offline Greolt

*
  • 956 956
    • View Profile
Re: Feed rate on start up.
« Reply #1 on: April 22, 2009, 09:46:30 AM »
Put it in the initialisation string in general config

F1000 for example.

Greg
Logged

Offline Jens H

*
  • 15 15
    • View Profile
Re: Feed rate on start up.
« Reply #2 on: April 23, 2009, 02:58:28 AM »
Thanks. That do the trick.
Logged
Pages: 1   Go Up
« previous next »