Hello Guest it is March 28, 2024, 05:09:33 PM

Author Topic: Turn G3 feedrate problem  (Read 12464 times)

0 Members and 1 Guest are viewing this topic.

melee

*
Re: Turn G3 feedrate problem
« Reply #20 on: May 11, 2009, 01:00:45 PM »

Hi Hood

I will have to test some more but using R parameter does seem to 'cure' the problem for now.

I didn't know that R worked in turn, will try it. It certainly would save me a lot of time when handwriting code that's for sure.

I knew R could be used in turning centres but also that some controllers do not support it.
Specifying the centre point with I K (and J on mills) seems to work everywhere, which I why I tried to use it.

Hopefully those parameters will be fixed before too long

cheers

Melee