Hello Guest it is July 18, 2019, 12:07:55 PM

Author Topic: Y Axis racking when sent to "Home"  (Read 2092 times)

0 Members and 1 Guest are viewing this topic.

Y Axis racking when sent to "Home"
« on: December 20, 2010, 08:10:28 PM »
I have 2 steppers on the y axis gantry which is R&P one on each side, they are the same brand, bought at the same time. Well the problem is when I "Home" the Y axis, one motor runs faster than the other. The odd part is when I jog or say "Go to zero" then they are fine. Any Suggestions? Thanks   Richard

Offline BR549

*
  •  6,874 6,874
    • View Profile
Re: Y Axis racking when sent to "Home"
« Reply #1 on: December 20, 2010, 09:44:58 PM »
In config check the Home speed % for each motor sounds like one is differrent.

(;-) TP

Offline ger21

*
  • *
  •  6,288 6,288
    • View Profile
    • The CNC Woodworker
Re: Y Axis racking when sent to "Home"
« Reply #2 on: December 20, 2010, 11:27:47 PM »
Same thing happened to me the other day. Terry's answer is correct.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: Y Axis racking when sent to "Home"
« Reply #3 on: December 23, 2010, 06:45:49 PM »
Thank you very much!!! That was it.