Hello Guest it is July 19, 2019, 02:39:50 AM

Author Topic: Non persistance when doing config setup  (Read 6050 times)

0 Members and 1 Guest are viewing this topic.

Re: Non persistance when doing config setup
« Reply #10 on: July 28, 2006, 11:30:13 AM »
Brian I made the change, closed Mach and they stayed in place. Then I changed the motor pins to get it referencing in the correct direction and that screw my jog directions up. Is there a chance that the referencing code is reversed?

Mike
Re: Non persistance when doing config setup
« Reply #11 on: July 28, 2006, 11:43:49 AM »
You can change the Home Negative  state under the config/ Homing and Limits

Hope that helps
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Non persistance when doing config setup
« Reply #12 on: July 28, 2006, 11:48:24 AM »
Thanks Brian......sometimes I get tunnel vision :-[

Mike
Re: Non persistance when doing config setup
« Reply #13 on: July 31, 2006, 12:10:38 PM »
Hi Brian, Art and or anyone else who might know. ;D

I need to be able to manually override my persitant limit switches and can't. I finally found the check box on the settings page.....thinking all this time it was in the congif :-[, but I cannot get a green led. This is all I need to be able to go ahead with the test. I may not actually since I not over the strep throat yet, but am getting there.

Mike